Epoxy resin Woodresin coating system 1.7 kg

Epoxy resin Woodresin coating system 1.7 kg

The Premium Coating System was specially developed for coating and sealing small workpieces, surfaces and wooden washbasins.

This resin system provides long-lasting protection for wood, wooden workpieces and antiques.

Technical Data

• Minimum pouring height: 1 mm
• Maximum pouring height: 1 cm
• Mixing ratio resin : hardener: 100 : 55
• Processing temperature: 20 °C
• Processing time at 20 °C: 15 -20 min
• Tack-free / next layer possible at 20 °C: 12 hours
• Deformable after: 24 hours
• Final strength: 7 days (After reaching final strength: intermediate sanding required for casting the next layer!)
• Heat resistant up to: 70 °C
• Content: 1.7 kg
• Storage: dry, at 10-25 °C, without exposure to sunlight
• Storage stability: approx. 6 - 9 months in the sealed original container

Features and advantages

• The resin and hardener set comes in the correct mixing ratio of 100:55.
• The epoxy resin is suitable, for example, as a cold glaze for jewellery or turned workpieces.
• The viscous consistency means that even vertical surfaces can be sealed well.
• Suitable for colouring with a maximum of 10% colour paste, pigment or concentrate.
• Temperature-resistant up to 70 °C.
• Important: Potting volume and layer thickness are interdependent. The thicker the layer, the smaller the mixing volume must be!
• An ambient temperature above 20 °C can cause the mixture to boil and lead to boiling bubbles, stress cracks and discolouration!
• Not suitable for layer thicknesses over 1 cm.
• Processing instructions: The objects to be embedded must be clean and free of dust, oil and grease. The moisture content of the wood must be below 13%.