ENT 3 Cutter Set for Dovetail Template

Tine cutter set for metric tine cutting templates

Fits the ENT tine template

This 3-piece cutter set is the optimal addition for all metric tine cutting templates. It Trimming Router Cutter is equipped with a metric ball bearing, so that in combination with the ENT Tine template or other metric templates, stable finger and dovetail joints can be produced. Due to the cutting edge at the Trimming Router Cutters, these can be used for Boring also

Technical Data

ENT Trimming Router Cutter 12.7 x 19 mm

• Diameter (A): 12,7 mm
• Width (B): 19 mm
• Cutting: 2 + 1 (with drilling edge)
• Shank (C): 8 mm
• Shanklength (D): 32 mm
• Total length (GL): 55 mm
• Ball bearing (KL): 12.7 mm

ENT Trimming Router Cutter 12,7 x 25 mm

• Diameter (A): 12,7 mm
• width (B): 25 mm
• Cutting: 2 + 1 (with drilling edge)
• Shank (C): 8 mm
• Shank length (D): 32 mm
• Total length (GL): 62 mm
• Ball bearing (KL): 12.7 mm

ENT Tine cutter 12,7 x 19,05 mm E8° - Ball bearing 16 mm -

• Ball bearing (KL): 16 mm
• Angle (E): 8
• Diameter (D): 12,7 mm
• Working length (NL): 19.05 mm
• Cutting (Z): 2
• Shank (S): 8 mm
• Shanklength (SL): 38 mm

Features and advantages

• Cutting in carbide (HW)
• Cutter dimensions are optimally matched to the ENT tine template
• Suitable for manual router and stationary router
• All ball bearings can be replaced. Fastening at Trimming Router Cutters with spring washer and at the tine cutter with a locking ring
• With the additional ball bearing matching the flush milling cutter, finger tines with the same tine width can also be milled with the template

Scope of delivery

• 1x ENT Tine cutter
• 2x ENT Trimming Router Cutter

Manufacturer